USB-Serial: Can You Change the UART Pin Type? – KBA89356
Anonymous
Not applicable
Oct 25, 2013
06:35 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Oct 25, 2013
06:35 AM
Version: **
Question: Is it possible to change the UART pin type (2-pin, 4-pin, or 6-pin) using UART APIs after the device has been programmed?
Answer:
No. The UART pin type (2-pin, 4-pin, or 6-pin) cannot be changed after the device has been programmed.
The UART APIs will allow you to change only the following configurations:
1. Baud rate
2. Data width
3. Stop bits
4. Parity
5. Drop packets on RX error
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous