CapSense® Slider and RGB LED Example using the EZ-BLE™ Creator Module – KBA97020

Version 3

    Version: *B

     

    Question:
    Does Cypress provide a CapSense® slider and RGB LED example project for the EZ-BLE Creator Module (CYBLE-022001-00)?

     

    Answer:
    Yes, the project can be downloaded along with the user guide from the GitHub location: https://github.com/cypresssemiconductorco/EZ-BLE_PRoC_Module/tree/master/Example_projects


    The project can be programmed on the EZ-BLE Creator Evaluation Board (CYBLE-022001-EVAL) plugged on to a BLE Pioneer Kit (CY8CKIT-042-BLE) baseboard.


    This project is identical to the example project available as part of the BLE Pioneer Kit (CY8CKIT-042-BLE), the only difference being pin mapping changes. These changes are necessary to accommodate the difference in pin mapping between the CYBLE-022001-EVAL and the CY8CKIT-042-BLE baseboard (explained in the CYBLE-022001-EVAL quick start guide).

     

    Downloading the Example Projects

    The following steps should be followed to download the complete project and user guide:

     

    1. Go to the example project page on github.com and select “CapSense_Slider_and_RGB_LED.zip” as shown in the figure below.

                            

         2.  Select “Raw” button, as shown in the following figure. All the project files and user guide will be downloaded as a .zip file.      
            

     

     

    Supported Kits and Software

     

    Project

    PSoC Creator

    Version

    Compiler

    Development Kits

    V3.1 SP2

    V3.1 SP1 or lower

    GCC

    MDK

    RVDS

    CY8CKIT-042-BLE with CYBLE-022011-EVAL

    CY8CKIT-042-BLE with PRoC BLE module (CY5671 or CY5674)

    CY8CKIT-042_BLE with PSoC 4 BLE module (CY8CKIT-142 or CY8CKIT-141)

    CapSense® Slider and RGB LED Example for
    EZ-BLE™ Creator Module

    YES

    NO

    YES

    YES

    YES

    YES

    NO

    NO