Selecting JTAG or SWD debug protocol in PSoC Creator
Employee
Mar 03, 2011
08:16 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Mar 03, 2011
08:16 PM
Question: How do I select JTAG or SWD (Serial Wire Debug) debug protocol in PSoC creator?
Answer:
The debug port is selected using system editor tab in the design wide resource file. It sets the debugging interface that the chip expects to use upon power up. The system editor screen shot showing debug port selection is given below.
Labels
Rate this article: