Configuration of Low-Noise LDO Linear Regulator
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: How do I configure to use Low-Noise LDO Linear Regulator in CYRF6936?
Answer:
In this case, VBAT, VCC, and VREG are all tied to the output of the low-noise LDO. The PMU boost function is not use. The inductor and diode are not used. L/D pin is connected to ground. The only PMU function is the 1.8V regulator for the core.
Labels
- Tags:
- rf transceivers
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous