Can you read out an M8 OTP once it's programmed? Assuming the answer is YES how do I prevent this?
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: Can you read out an M8 OTP once it's programmed? Assuming the answer is YES how do I prevent this?
Answer:
On the Hi-Lo programmer GUI (Cystart.exe), there is a "Security" button. Once this fuse is blown, the code will be protected. When it is read, only FFh's are shown.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous