Attachments are accessible only for community members.
Redirecting Appliance UART LED Output "Buttons" to GPIO Ports
Employee
Apr 28, 2015
09:23 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Apr 28, 2015
09:23 AM
Replace the …/apps/demo/appliance/appliance.c and …/resources/apps/appliance/top_web_page_top.html with attached copies.
Then build and download the updated appliance application to your target EVB, example is BCM943362WCD4 EVB “demo.appliance-BCM943362WCD4 download run“.
Follow the same steps described in the appliance demo, Demo of the "Appliance Application" in WICED SDK, to associate EVB to your network and go to the website served by the EVB.
Use the buttons to toggle Red and Green LEDs on the BCM943362WCD4 EVB, as shown below screen shot.
Labels
Rate this article: