• Concurrent AP and STA

    Introduction  This blog is to demonstrate the setup of Concurrent AP and STA in a linux host(i.MX6 was used for this purpose). Pre-requisites  The host should have the following utilities/daemons running: ...
    VinayakS_26
    last modified by VinayakS_26
  • Running  BlueZ on CY Part

    Introduction  The blog is to run BlueZ stack on a linux  host machine to initialize Cypress Bluetooth Controller, which is connected to Ubuntu machine through UART transport. The blog contains the necessary...
    VinayakS_26
    last modified by VinayakS_26
  • Getting started on Linux Driver Backporting - FMAC

    This post explains how to cross-compile the Linux kernel and Backport driver sources against ARM platform and loading the binaries to the target. The end users who are interested in bringing up their target with linux...
    PrasanthK_06
    last modified by PrasanthK_06
  • HostApd setup in Linux

    The objective of this post is to install hostapd on the ARM target and ready to go for its use. This post explains the instructions on how to setup dependent hostapd libraries and cross-compile the sources against ARM...
    PrasanthK_06
    last modified by PrasanthK_06
  • Quick Start with FMAC Driver on iMX6 UVELK and Murata 1DX

    This tutorial is intended as an introduction to adding the FMAC driver to your iMX6 UVELK running Freescale 4.1.15.x with Murata 1DX. This guide assumes that the 4.1.15 kernel is already booted up and running on your ...
    JacobT_81
    last modified by JacobT_81
  • Linux Device Tree - FMAC

    This blog post explains the basic concepts of Linux Device Tree and takes some examples to explain how the FMAC WiFi/BT Device Tree has built up for NXP's i.MX6 platform. Introduction A Device Tree is a data structur...
    PrasanthK_06
    last modified by PrasanthK_06
  • List of Kernel patches - FMAC

    This blog post shows GIT command usage to get the list of commit logs. Refer this link to find the list of patches submitted in kernel.org.   List of FMAC changes The following GIT command shall be used to fi...
    PrasanthK_06
    last modified by PrasanthK_06
  • Supplicant in Linux

    The objective of this post is to install wpa_supplicant on the ARM target running Linux.   Introduction wpa_supplicant is a WPA Supplicant for Linux, BSD, Mac OS X, and Windows with support for WPA and WPA2 (IE...
    PrasanthK_06
    last modified by PrasanthK_06
  • FMAC Supported chipset - Linux

    The Linux wireless page and this updated wiki page lists the wireless chipset that Linux releases support.   The following table shows the list of Cypress's firmware releases with FMAC support in Linux.   ...
    PrasanthK_06
    last modified by PrasanthK_06
  • WPA Supplicant with bcmdhd

    1. First follow this to prepare your iMX. Quick Start with iMX6 Ultralite EVK and Mass Market Modules   2. Below are logs which shows using WPA supplicant with bcmdhd.   3. Below restart_wpa_supplicant ...
    venkats_16
    last modified by venkats_16
  • BSA Configuration for Setting the BT MAC Address (bd_addr)

    BSA server, bsa_server, reads the configuration parameters from the bt_config.xml text file. If the bt_config.xml text file is not present, one will be created and the random Bluetooth MAC address will be used to setu...
    seyhana_
    last modified by seyhana_