Anonymous
Not applicable
Nov 24, 2014
11:27 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 24, 2014
11:27 AM
The Broadcom iBeacon reference design is based on the WICED SMART BCM20737S Bluetooth Low Energy transceiver.
The iBeacon hardware provides the following features:
- 4 Connection pads (UP_TX, UP_RX, VDDIO and GND) to enable programming of the device
- SW1: An on/off slide switch
- SW2: Push button to disable all radio function
- SW3: A push button for internal EEPROM firmware recovery
- The procedure to recover the EEPROM is as follows:
- Power off the device
- Hold down SW3
- Power on the device
- Release SW3
- Proceed to program the new firmware into the device
- The procedure to recover the EEPROM is as follows:
Labels
- Labels:
-
iBeacon (Module)
0 Replies